Elk Grove 10 Minute Water Heater Maintenance Check

Posted by on Feb 26, 2014 in Water Heater Repair Elk Grove

We are going to put you to work today, however only for about 10 minutes. Yep, that’s all it will consider these two crucial water heater maintenance jobs; nevertheless, Water Heater Repair Elk Grove knows they will do an excellent task of helping with three things:

  • Having your water heater last as long as possible (that will save you money).
  • Seeing to it the water heater runs safely (we do not want it to explode).
  • Having it run as energy efficiently as possible (also conserving you money).

So with that in mind, are you prepared to spend 10 minutes once or twice a year to assist in saving some money? Water Heater Repair Elk Grove CA thought so.

Testing the T&P Relief Valve

Frequently called the T&P Valve, or the temperature and pressure relief valve, has a vital task. It assists make sure excess pressure does not develop inside the water storage tank, or in much more basic terms, it makes certain the water heater does not explode. As the picture shows, it has a lever or little manage on it. All you need to do is lift it part means and then release it. Ideally, it snapped back to its closed position quickly. If it is working effectively, a little water can be heard entering into the drain pipe below the lever you just lifted and you perhaps heard some pressure being released. If none of these things have occurred throughout the test, the valve will should be changed.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Perform a Mimi Water Heater Tank Flush

By nature, rust and rust will happen inside the water storage tank thanks to the chemical reactions taking place with all the components inside that are required to heat up the water. We will not get overly technical here, however it is simple to help avoid this from happening by doing a flush or draining of all or a portion of the water in the storage tank.

For simply a small flush, place a pail under the drain valve below the tank. Open the drain valve and fill the pail with water. Drain a minimum of a few gallons of water in total. Let the water sit in the pail for a couple of minutes to settle and examine if there is much that settles to the bottom of the bucket. If there is, if the water heater has actually not been drained for a very long time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will want to turn the temperature dial down and may desire to let the water cool down for about an hour first so it is not too hot while draining it. Likewise, it would be easier to connect a hose to the drain valve and let the water go outside instead of making use of containers.

If the water looks fairly clean and clear from the tiny test you should be all set. When the water heater has an excessive quantity of sediment inside of it, it can make loud popping sounds and it lowers its effectiveness too.

Though water heaters are fairly maintenance free and easy to operate, any time you feel the smallest awkward or are not sure of exactly what to do, it is always best to have a plumbing professional aid with the situation.

Water Heater Repair Elk Grove